Difference between revisions of "Renesas RZ/T2M-RSK"
(Created page with "__TOC__ This article describes specifics for the Renesas RZ/T2M-RSK evaluation board. 450px == Minimum requirements == * J-Link software V7.6...") |
(→Preparing for J-Link) |
||
| Line 9: | Line 9: | ||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
| − | *Connect the J-Link to the |
+ | *Connect the J-Link to the debug header (J13 or J20) |
| − | *Power the board via external power supply / power jack (CN6) |
+ | *Power the board via USB C (CN5) or external power supply / power jack (CN6) |
*Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
*Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
Revision as of 16:41, 7 July 2022
This article describes specifics for the Renesas RZ/T2M-RSK evaluation board.
Minimum requirements
- J-Link software V7.68 or later
Preparing for J-Link
- Connect the J-Link to the debug header (J13 or J20)
- Power the board via USB C (CN5) or external power supply / power jack (CN6)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
TBD
SETUP
TBD
