Rowley CrossWorks
In order to use J-Link with Rowley CrossWorks install the latest SEGGER software and documentation pack. Please verify that your J-Link software is up to date. After that, start CrossWorks and open your project.
Used components
IDE | Debug Probe | J-Link SW Version | Evalboard |
---|---|---|---|
CrossWorks V2.1 | J-Link | V4.31d | AT91SAM7S-EK |
Setup steps
- Press Ctrl+Alt+T to open the Targets window, which shows a list of debug probes supported by Rowley CrossWorks
- Select and connect to Segger J-Link from the Targets window as shown below
- Press Ctrl+Alt+W to open the Target Properties window
- Set the location of the latest J-Link DLL file which comes with the software and documentation pack.
Ready to Go
Now you can start debugging and use J-Link with Rowley Crossworks. Please note that some ARM cores require an init file to be executed before debugging can start; this init file typically initializes certain parts of the ARM chip (memory access) that are required for the RAM to function.