SEGGER Flash Loader
Contents
Open Flash Loader
Introduction
As the number of devices being available is steadily growing and sometimes in an early stage of the MCU development only a few samples/boards are available that may not be provided to third parties (e.g. SEGGER) to add support for a new device. Also the existence of the device may have confidential status, so it might not be mentioned as being supported in public releases yet. Therefore it might be desirable to be able to add support for new devices on your own, without depending on SEGGER and a new release of the J-Link Software & Documentation package being available.
The J-Link DLL allows customers to add support for new devices on their own. It is also possible to edit / extend existing device support by for example adding new flash banks (e.g. to add support for internal EEPROM programming or SPIFI programming). This article explains how new devices can be added to the DLL and how existing ones can be edited / extended.
General Procedure
By default, the J-Link DLL comes with a build-in device database that defines which device names are known and therefore officially supported by the J-Link DLL and software that uses the J-Link DLL. This list can also be viewed on our website: https://www.segger.com/downloads/supported-devices.php
Additionally, the build-in device database can be extended by specifying devices in an XML file, named JLinkDevices.xml. It is also possible to edit / extend an device from the built-in device database via this XML file. There are different places where the JLinkDevices.xml can be referenced from (see list below). In case of several JLinkDevices.xml files are used, supplement each other as in the order specified below:
- In the same directory as the J-Link DLL (JLinkARM.dll)
- In the same directory as the J-Link settings file. The location of the settings file depends on the IDE / software being used.
- In the directory specified using the J-Link Command String JLinkDevicsXMLPath = <Path>
