STM3210C-EVAL
Revision as of 16:47, 7 August 2023 by Simon Buchholz (talk | contribs) (Created page with "__TOC__ This article describes specifics for the ST STM3210C-EVAL evaluation board.<br> 400px == Preparing for J-Link == *Power the board via...")
This article describes specifics for the ST STM3210C-EVAL evaluation board.
Preparing for J-Link
- Power the board via CN18(5V DC power jack)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
- Note select device: "STM3210C-EVAL".
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM3210C-EVAL.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.90
- Embedded Studio: V7.20
- Hardware: ST NUCLEO-F103RB
- Link: File:STM3210C-EVAL Projekt.zip
