STM32CubeIDE
STM32CubeIDE is an eclipse based IDE developed by ST. This article covers the usage of the STM32CubeIDE in combination with a SEGGER J-Link.
Contents
Using STM32CubeIDE with J-Link
In the following, a short step-by-step tutorial how to create a new STM32CubeIDE project to be used with J-Link, is given.
Adding J-Link support at installation time
- In STM32CubeIDE, J-Link is supported out-of-the-box if J-Link support is selected to be added at installation time.
Setting up a project
- Click on File -> New -> STM32 Project
- After The STM32 Target Selection has opened, select the desired device/board you want to create a project for and click on Next.
- Select your desired Project Setup and click on Finish.
Setting up J-Link as debug Probe
- Open Run -> Debug Configurations...