Difference between revisions of "STM32F10X-128K-EVAL"
(→Preparing for J-Link) |
|||
| Line 1: | Line 1: | ||
| + | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Latest revision as of 15:24, 8 May 2024
This article describes specifics for the ST STM32F10X-128K-EVAL board.
Preparing for J-Link
- Power the board (5V DC power jack)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
- Note select device: "STM32F103ZE".
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM32F10X-128K-EVAL.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.90
- Embedded Studio: V7.20
- Hardware: ST NUCLEO-F103RB
- Link: File:STM32F10X-128K-EVAL.zip
