STM32H743I-EVAL
Contents
This article describes specifics for the ST STM32H743I-EVAL evaluation board.
Preparing for J-Link
- Connect the J-Link to ......
- Power the board via........
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM32H743I-EVAL.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.86d
- Embedded Studio: V7.10
- Hardware: ST STM32H743I-EVAL
- Link: File:ST STM32H743I-EVAL TestProject ES V710.zip
SWO
SWO is supported on the STM32H743I-EVAL.
Requirements
In order to make SWO working correctly, min. J-Link software V6.34 is required. Previous versions are not guaranteed to work correctly with SWO.
Sample projects
The following sample projects that demonstrate SWO on the STM32H743I-EVAL are available:
This example project does not require any extra settings by the user. The SWO stream can be viewed with e.g. J-Link SWO Viewer which is included in the J-Link Software and Documentation Pack and is available for free. This project was created with Embedded Studio V3.40.
IAR does not handle the special setup needed for this particular target device automatically so SWO printf will only work when using Ozone. The example project contains a Ozone configuration that will work out-of-the-box.