Difference between revisions of "STM32VLDISCOVERY"

From SEGGER Wiki
Jump to: navigation, search
(Created page with "__TOC__ This article describes specifics for the ST STM32VLDISCOVERY board.<br> 400px == Preparing for J-Link == *Power the board via (Min...")
 
Line 5: Line 5:
   
 
== Preparing for J-Link ==
  
== Preparing for J-Link ==
  +
  +
* Connect the board with jumping wires to your J-Link (see table below)<br>For information about the J-Link pinout please refer to the following page: [https://www.segger.com/products/debug-probes/j-link/technology/interface-description/#swd-connector-pinout J-Link SWD pinout].
  +
  +
{| class="wikitable"
  +
|-
  +
! J-Link 20 pin debug interface !! Pin on evaluation board
  +
|-
  +
| Pin 1 (VTref, red) || Pin 16 at CN7 pin header
  +
|-
  +
| Pin 4 (GND, black) || Pin 8 at CN7 pin header
  +
|-
  +
| Pin 7 (SWDIO, green) || Pin 4 at CN4 pin header
  +
|-
  +
| Pin 9 (SWCLK, yellow) || Pin 2 at CN4 pin header
  +
|-
  +
| Pin 15 (RESET, blue) || Pin 5 at CN4 pin header
  +
|}
  +
The result should be looking like this:
  +
  +
[[File:ST_NUCLEO-F030R8_wired.jpg | 500px | ST NUCLEO-F030R8 wired with jumper cables]]
   
 
*Power the board via (Mini USB)
  
*Power the board via (Mini USB)

Revision as of 14:32, 11 August 2023

This article describes specifics for the ST STM32VLDISCOVERY board.
ST STM32VLDISCOVERY.jpeg

Preparing for J-Link

  • Connect the board with jumping wires to your J-Link (see table below)
    For information about the J-Link pinout please refer to the following page: J-Link SWD pinout.
J-Link 20 pin debug interface Pin on evaluation board
Pin 1 (VTref, red) Pin 16 at CN7 pin header
Pin 4 (GND, black) Pin 8 at CN7 pin header
Pin 7 (SWDIO, green) Pin 4 at CN4 pin header
Pin 9 (SWCLK, yellow) Pin 2 at CN4 pin header
Pin 15 (RESET, blue) Pin 5 at CN4 pin header

The result should be looking like this:

ST NUCLEO-F030R8 wired with jumper cables

  • Power the board via (Mini USB)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

STM32VLDISCOVERY con.PNG

  • Note select device: "".

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM32VLDISCOVERY.
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=STM32VLDISCOVERY&oldid=15977"