Difference between revisions of "ST NUCLEO-F042K6"
| Line 8: | Line 8: | ||
*Power the board via CN1 (Micro USB) |
*Power the board via CN1 (Micro USB) |
||
| − | * |
+ | *Reflash the ST-LINK On-Board Into a J-Link [https://www.segger.com/products/debug-probes/j-link/models/other-j-links/st-link-on-board/ Guide] |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
| − | [[File:.PNG|400px]] |
+ | [[File:STM32F04K6_con.PNG|400px]] |
== Example Project== |
== Example Project== |
||
Revision as of 10:21, 4 August 2023
This article describes specifics for the ST NUCLEO-F042K6 evaluation board.
Preparing for J-Link
- Power the board via CN1 (Micro USB)
- Reflash the ST-LINK On-Board Into a J-Link Guide
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST NUCLEO-F042K6.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.90
- Embedded Studio: V7.20
- Hardware: ST NUCLEO-F031K6
- Link: File:.zip
