ST NUCLEO-F042K6
Revision as of 10:11, 4 August 2023 by Simon Buchholz (talk | contribs)
This article describes specifics for the ST NUCLEO-F042K6 evaluation board.
Preparing for J-Link
- Power the board via CN1 (Micro USB)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST NUCLEO-F042K6.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.90
- Embedded Studio: V7.20
- Hardware: ST NUCLEO-F031K6
- Link: File:.zip
