Difference between revisions of "ST NUCLEO-F070RB"
(Created page with "__TOC__ This article describes specifics for the ST NUCLEO-F070RB evaluation board.<br> 600px == Preparing for J-Link == *Power the board via...") |
|||
| Line 2: | Line 2: | ||
This article describes specifics for the ST NUCLEO-F070RB evaluation board.<br> |
This article describes specifics for the ST NUCLEO-F070RB evaluation board.<br> |
||
| − | [[File:ST NUCLEO-F070RB.jpeg| |
+ | [[File:ST NUCLEO-F070RB.jpeg|400px]] |
== Preparing for J-Link == |
== Preparing for J-Link == |
||
Revision as of 11:09, 4 August 2023
This article describes specifics for the ST NUCLEO-F070RB evaluation board.
Preparing for J-Link
- Power the board via CN1 (Micro USB)
- Reflash the ST-LINK On-Board Into a J-Link Guide
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST NUCLEO-F070RB.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.90
- Embedded Studio: V7.20
- Hardware: ST NUCLEO-F070RB
- Link: File:STM32F070RB Projekt.zip
