Difference between revisions of "ST NUCLEO-WBA52CG"
(Created page with "__TOC__ This article describes specifics for the ST NUCLEO-WBA52CG evaluation board.<br> '''[PICTURE OF BOARD]''' 450px == Preparing for J-Link...") |
|||
Line 2: | Line 2: | ||
This article describes specifics for the ST NUCLEO-WBA52CG evaluation board.<br> |
This article describes specifics for the ST NUCLEO-WBA52CG evaluation board.<br> |
||
+ | [[File:ST_NUCLEO-WBA52CG_STM32WBA52CG_board.jpg|450px]] |
||
− | '''[PICTURE OF BOARD]''' |
||
− | [[File:VENDOR_BOARDNAME.jpg|450px]] |
||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
Line 9: | Line 8: | ||
*Power the board via........ |
*Power the board via........ |
||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
+ | [[File:ST_NUCLEO-WBA52CG_STM32WBA52CG_connect|400px]] |
||
− | '''[PICTURE OF CONNECT]''' |
||
− | [[File:VENDOR_DEVICE_CONNECT.PNG|400px]] |
||
== Example Project== |
== Example Project== |
||
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the [SiliconVendor] [EvalBoardName].<br>It is a simple Hello World sample linked into the internal flash.<br> |
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the [SiliconVendor] [EvalBoardName].<br>It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
− | *J-Link software: |
+ | *J-Link software: V7.88k |
− | *Embedded Studio: |
+ | *Embedded Studio: V6.34.52b |
− | *Hardware: |
+ | *Hardware: ST NUCLEO-WBA52CG |
− | *Link: [[File: |
+ | *Link: [[File:ST_NUCLEO-WBA52CG_STM32WBA52CG_TestProject_ES_V634.zip]] |
Revision as of 11:24, 4 July 2023
This article describes specifics for the ST NUCLEO-WBA52CG evaluation board.
Preparing for J-Link
- Connect the J-Link to ......
- Power the board via........
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the [SiliconVendor] [EvalBoardName].
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.88k
- Embedded Studio: V6.34.52b
- Hardware: ST NUCLEO-WBA52CG
- Link: File:ST NUCLEO-WBA52CG STM32WBA52CG TestProject ES V634.zip