ST NUCLEO-WBA52CG

From SEGGER Wiki
Revision as of 11:16, 4 July 2023 by Torben.scharping (talk | contribs) (Created page with "__TOC__ This article describes specifics for the ST NUCLEO-WBA52CG evaluation board.<br> '''[PICTURE OF BOARD]''' 450px == Preparing for J-Link...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This article describes specifics for the ST NUCLEO-WBA52CG evaluation board.
[PICTURE OF BOARD] 450px

Preparing for J-Link

  • Connect the J-Link to ......
  • Power the board via........
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

[PICTURE OF CONNECT] VENDOR DEVICE CONNECT.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the [SiliconVendor] [EvalBoardName].
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=ST_NUCLEO-WBA52CG&oldid=15411"