Difference between revisions of "ST NUCLEO-WBA55CG"
(Created page with "__TOC__ This article describes specifics for the ST NUCLEO-WBA55CG evaluation board.<br> 450px == Preparing for J-Link == *...") |
(No difference)
|
Revision as of 11:52, 25 March 2024
This article describes specifics for the ST NUCLEO-WBA55CG evaluation board.
450px
Preparing for J-Link
- Connect the J-Link to CN3-8(GND) CN3-9(SWDIO) CN3-11(SWDCLK) CN3-12(VTref) CN3-14(Reset).
- Set Jumper JP1 to 9-10 (VBUS)
- Power the board via CN15 (USB-C)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the [SiliconVendor] [EvalBoardName].
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.96c
- Embedded Studio: V7.30
- Hardware: ST NUCLEO-WBA55CG
- Link: File:ST NUCLEO-WBA55CG STM32WBA55CG TestProject ES V730.zip
