Difference between revisions of "ST NUCLEO-WBA55CG"
Line 12: | Line 12: | ||
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST NUCLEO-WBA55CG.<br>It is a simple Hello World sample linked into the internal flash.<br> |
====SETUP==== |
====SETUP==== |
||
*J-Link software: V7.96c |
*J-Link software: V7.96c |
Latest revision as of 17:26, 2 April 2024
This article describes specifics for the ST NUCLEO-WBA55CG evaluation board.
Preparing for J-Link
- Connect the J-Link to CN3-8(GND) CN3-9(SWDIO) CN3-11(SWDCLK) CN3-12(VTref) CN3-14(Reset).
- Set Jumper JP1 to 9-10 (VBUS)
- Power the board via CN15 (USB-C)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST NUCLEO-WBA55CG.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.96c
- Embedded Studio: V7.30
- Hardware: ST NUCLEO-WBA55CG
- Link: File:ST NUCLEO-WBA55CG STM32WBA55CG TestProject ES V730.zip