Difference between revisions of "ST STM320518-EVAL"
Line 1: | Line 1: | ||
__TOC__ |
__TOC__ |
||
− | This article describes specifics for the ST |
+ | This article describes specifics for the ST STM3210C-EVAL evaluation board.<br> |
− | [[File:ST |
+ | [[File:ST STM3210C-EVAL.jpeg|400px]] |
== Preparing for J-Link == |
== Preparing for J-Link == |
||
− | *Power the board via CN18 |
+ | *Power the board via CN18(5V DC power jack) |
− | |||
− | *Reflash the ST-LINK On-Board Into a J-Link [https://www.segger.com/products/debug-probes/j-link/models/other-j-links/st-link-on-board/ Guide] |
||
− | |||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
− | [[File: |
+ | [[File:STM3210C-EVAL_con.PNG|400px]] |
+ | *Note select device: "STM32F107VC". |
||
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM3210C-EVAL.<br>It is a simple Hello World sample linked into the internal flash.<br> |
====SETUP==== |
====SETUP==== |
||
*J-Link software: V7.90 |
*J-Link software: V7.90 |
||
*Embedded Studio: V7.20 |
*Embedded Studio: V7.20 |
||
− | *Hardware: ST |
+ | *Hardware: ST NUCLEO-F103RB |
− | *Link: [[File: |
+ | *Link: [[File:STM3210C-EVAL_Projekt.zip]] |
Revision as of 16:51, 7 August 2023
This article describes specifics for the ST STM3210C-EVAL evaluation board.
Preparing for J-Link
- Power the board via CN18(5V DC power jack)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
- Note select device: "STM32F107VC".
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM3210C-EVAL.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.90
- Embedded Studio: V7.20
- Hardware: ST NUCLEO-F103RB
- Link: File:STM3210C-EVAL Projekt.zip