Difference between revisions of "ST STM320518-EVAL"
(Created page with "__TOC__ This article describes specifics for the ST NUCLEO-32F072B-DISCO evaluation board.<br> 400px == Preparing for J-Link == *Power...") |
(Blanked the page) (Tag: Blanking) |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | __TOC__ |
||
| − | |||
| − | This article describes specifics for the ST NUCLEO-32F072B-DISCO evaluation board.<br> |
||
| − | [[File:ST NUCLEO-32F072B-DISCO.jpeg|400px]] |
||
| − | |||
| − | == Preparing for J-Link == |
||
| − | |||
| − | *Power the board via CN1 (Mini USB) |
||
| − | |||
| − | *Reflash the ST-LINK On-Board Into a J-Link [https://www.segger.com/products/debug-probes/j-link/models/other-j-links/st-link-on-board/ Guide] |
||
| − | |||
| − | * Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
| − | [[File:STM3232F072B-DISCO_con.PNG|400px]] |
||
| − | *Note: select device: "STM32F072R8". |
||
| − | |||
| − | == Example Project== |
||
| − | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST NUCLEO-32F072B-DISCO.<br>It is a simple Hello World sample linked into the internal flash.<br> |
||
| − | ====SETUP==== |
||
| − | *J-Link software: V7.90 |
||
| − | *Embedded Studio: V7.20 |
||
| − | *Hardware: ST NUCLEO-32F072B-DISCO |
||
| − | *Link: [[File:STM3232F072B-DISCO_Projekt.zip]] |
||
