Difference between revisions of "ST STM320518-EVAL"
(Blanked the page) (Tag: Blanking) |
|||
(One intermediate revision by the same user not shown) | |||
Line 1: | Line 1: | ||
− | __TOC__ |
||
− | |||
− | This article describes specifics for the ST STM320518-EVAL evaluation board.<br> |
||
− | [[File:ST STM320518-EVAL.jpeg|400px]] |
||
− | |||
− | == Preparing for J-Link == |
||
− | |||
− | *Power the board via CN18 (PSU DC 5V) |
||
− | |||
− | *Reflash the ST-LINK On-Board Into a J-Link [https://www.segger.com/products/debug-probes/j-link/models/other-j-links/st-link-on-board/ Guide] |
||
− | |||
− | * Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
− | [[File:STM320518-EVAL_con.PNG|400px]] |
||
− | |||
− | == Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM320518-EVAL.<br>It is a simple Hello World sample linked into the internal flash.<br> |
||
− | ====SETUP==== |
||
− | *J-Link software: V7.90 |
||
− | *Embedded Studio: V7.20 |
||
− | *Hardware: ST STM320518-EVAL |
||
− | *Link: [[File:STM320518-EVAL_Projekt.zip]] |