Difference between revisions of "ST STM320518-EVAL"
(Blanked the page) (Tag: Blanking) |
|||
Line 1: | Line 1: | ||
− | __TOC__ |
||
− | |||
− | This article describes specifics for the ST STM3210C-EVAL evaluation board.<br> |
||
− | [[File:ST STM3210C-EVAL.jpeg|400px]] |
||
− | |||
− | == Preparing for J-Link == |
||
− | |||
− | *Power the board via CN18(5V DC power jack) |
||
− | * Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
− | [[File:STM3210C-EVAL_con.PNG|400px]] |
||
− | *Note select device: "STM32F107VC". |
||
− | |||
− | == Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM3210C-EVAL.<br>It is a simple Hello World sample linked into the internal flash.<br> |
||
− | ====SETUP==== |
||
− | *J-Link software: V7.90 |
||
− | *Embedded Studio: V7.20 |
||
− | *Hardware: ST NUCLEO-F103RB |
||
− | *Link: [[File:STM3210C-EVAL_Projekt.zip]] |