ST STM320518-EVAL

This article describes specifics for the ST STM320518-EVAL evaluation board.

Preparing for J-Link

• Power the board via CN1 (---)

• Reflash the ST-LINK On-Board Into a J-Link Guide

• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

400px

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM320518-EVAL.
It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: V7.90
• Embedded Studio: V7.20
• Hardware: ST STM320518-EVAL
• Link: File:STM320518-EVAL Projekt.zip