ST STM320518-EVAL
Revision as of 14:38, 4 August 2023 by Simon Buchholz (talk | contribs)
This article describes specifics for the ST STM320518-EVAL evaluation board.
Preparing for J-Link
- Power the board via CN18 (PSU DC 5V)
- Reflash the ST-LINK On-Board Into a J-Link Guide
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM320518-EVAL.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.90
- Embedded Studio: V7.20
- Hardware: ST STM320518-EVAL
- Link: File:STM320518-EVAL Projekt.zip