ST STM32F072B-DISCO
Revision as of 14:06, 4 August 2023 by Simon Buchholz (talk | contribs)
This article describes specifics for the ST NUCLEO-32F072B-DISCO evaluation board.
Preparing for J-Link
- Power the board via CN1 (Mini USB)
- Reflash the ST-LINK On-Board Into a J-Link Guide
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
- Note: select device: "STM32F072R8".
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST NUCLEO-32F072B-DISCO.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.90
- Embedded Studio: V7.20
- Hardware: ST NUCLEO-32F072B-DISCO
- Link: File:STM3232F072B-DISCO Projekt.zip
