ST STM32H573I-DK
This article describes specifics for the ST STM32H573I-DK evaluation board.
Preparing for J-Link
- On the back side of the board close jumper J1 so that the board can be accessed with an external debug connector.
- Connect the J-Link to the 10 pin debug connector CN12 which is located on the backside of the board.
- On the display side of the board set jumper JP4 to 3-4 (USB-PD) for power via USB-C (CN17).
- Power the board via USB-C (CN17).
The result should look like this:
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the [SiliconVendor] [EvalBoardName].
It is a simple Hello World sample linked into the internal flash.
Setup
- J-Link software: V7.84b
- Embedded Studio: V6.30
- Hardware: ST STM32H573I-DK
- Link: File:ST STM32H573I-DK HelloWorld.zip