Difference between revisions of "ST STM32H7"
(Created page with "__TOC__ = SWO = On the STM32H7 series devices from ST SWO is supported. However, a few device specifics apply which are described in the following section. == SWO register a...") |
(→SWO register access) |
||
Line 7: | Line 7: | ||
For most Cortex-M devices, the SWO registers are accessible by the AHB-AP. This is not the case for the STM32H7 series devices. In this case the registers need to be partially accessed by the APB-AP. |
For most Cortex-M devices, the SWO registers are accessible by the AHB-AP. This is not the case for the STM32H7 series devices. In this case the registers need to be partially accessed by the APB-AP. |
||
− | '''Note:''' J-Link handles the current setting of this registers automatically. J-Link software version V6. |
+ | '''Note:''' J-Link handles the current setting of this registers automatically. J-Link software version V6.33a or later is required. |
Revision as of 11:33, 14 May 2018
Contents
SWO
On the STM32H7 series devices from ST SWO is supported. However, a few device specifics apply which are described in the following section.
SWO register access
For most Cortex-M devices, the SWO registers are accessible by the AHB-AP. This is not the case for the STM32H7 series devices. In this case the registers need to be partially accessed by the APB-AP.
Note: J-Link handles the current setting of this registers automatically. J-Link software version V6.33a or later is required.
Note: The settings are applied by a compiled .JLinkScriptfile located in the J-Link software installation folder under /Devices, should you need the original source it can be requested at support@segger.com