Difference between revisions of "ST STM32U575I-EV"
(→Preparing for J-Link) |
m (Torben.scharping moved page STM32U575I-EV to ST STM32U575I-EV) |
(No difference)
| |
Revision as of 13:42, 28 June 2023
This article describes specifics for the ST STM32U575I-EV evaluation board.
Preparing for J-Link
- Connect the J-Link to CN12.
- Power the board via CN1.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM32U575I-EV.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.74
- Embedded Studio: V4.52b
- Hardware: ST STM32U575I-EV
- Link: File:VENDOR DEVICENAME TestProject ES V452b.zip
