ST STM32U585

This article describes specifics for the ST STM32U585 evaluation board.

Preparing for J-Link

• Connect the J-Link to ......
• Power the board via........
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM32U585.
It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: V6.74
• Embedded Studio: V4.52b
• Hardware: ST STM32U585
• Link: File:VENDOR DEVICENAME TestProject ES V452b.zip