Starter Kit A34M418VLN v1.2
This article describes specifics for the NXP JN5189-DK006 evaluation board. The board supports different Upgrade boards. It can be used to test & verify QN9090 and JN5189 support.
Minimum requirements
- J-Link software V6.93a or later
Preparing for J-Link
- Connect the J-Link to the pins as seen in the image/table below:
Cable | JTAG-Pin |
---|---|
Red | VTref |
Blue | TMS |
Black | GND |
Yellow | TCK |
- Power the board via usb power supply
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ABOV Starter Kit A34M418VLN v1.2. It is a simple Hello World sample linked into the internal flash. SETUP
- J-Link software: V6.93a
- Embedded Studio: V5.32a
- Hardware: Starter Kit A34M418VLN v1.2
- Link: File:ABOV A34M418VLN TestProject ES V532a.zip