Difference between revisions of "Syntacore SCR1"
(→Preparing for J-Link) |
|||
Line 14: | Line 14: | ||
! Description |
! Description |
||
|- |
|- |
||
− | | |
+ | |7 |
|13 |
|13 |
||
|TDO |
|TDO |
||
|- |
|- |
||
− | | |
+ | |3 |
|3 |
|3 |
||
|nTRST |
|nTRST |
||
|- |
|- |
||
− | | |
+ | |4 |
|9 |
|9 |
||
|TCK |
|TCK |
||
|- |
|- |
||
− | | |
+ | |8 |
|5 |
|5 |
||
|TDI |
|TDI |
||
|- |
|- |
||
− | | |
+ | |10 |
|7 |
|7 |
||
|TMS |
|TMS |
Revision as of 17:57, 6 February 2018
This article describes specifics for the SiFive Arty FPGA Dev Kit.
Preparing for J-Link
Syntacore provides a reference FPGA bistream for the Digilent ARTY FPGA dev kit, which allows to implement a RISC-V core. The Digilent ARTY FPGA dev kit does not come with a standard debug connector but populates the debug JTAG signals on the JD connector of the eval board. Therefore, it needs to be manually wired in case J-Link shall be connected to it.
In the following, it is described how the pins of JD connector on the ARTY board needs to be wired to J-Link. All pins of the J-Link side refer to the standard 0.1" 20-pin connector of J-Link.
Pin ARTY | Pin J-Link | Description |
---|---|---|
7 | 13 | TDO |
3 | 3 | nTRST |
4 | 9 | TCK |
8 | 5 | TDI |
10 | 7 | TMS |
9 | 15 | nRESET |
11 | 4 | GND |
12 | 1 | VTref |
Note: The pins on the JD connector are numbered as follows:
6 | 5 | 4 | 3 | 2 | 1 |
12 | 11 | 10 | 9 | 8 | 7 |
<Photo>
Debugging in xxx
TBD Before continuing, make sure that you have J-Link software package Vxxx or later installed: Download J-Link software package
Minimum J-Link hardware requirements
Please note that RISC-V is not supported by older J-Link hardware models / revisions. For an overview about which models / revisions support RISC-V: List