TI Jacinto J721EXCP01EVM

From SEGGER Wiki
Revision as of 15:06, 6 October 2023 by Erik (talk | contribs) (Created page with "__TOC__ This article describes specifics for TI's Jacinto 7 common evaluation platform (J721EXCP01EVM). The base board can be used with the J721EXSOMG01EVM (TDA4VMx & DRA829V...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This article describes specifics for TI's Jacinto 7 common evaluation platform (J721EXCP01EVM). The base board can be used with the J721EXSOMG01EVM (TDA4VMx & DRA829Vx) or the J7200XSOMG01EVM (DRA821).
[PICTURE OF BOARD] 450px

Preparing for J-Link

Hardware: TI J721EXCP01EVM + TI J721EXSOMG01EVM (TDA4VMx & DRA829Vx) or TI J7200XSOMG01EVM (DRA821)

  • Install J-Link software: V7.94 (or later)
  • Connect the J-Link to the board via JTAG MIPI connector (non standard adapter is requireD)
  • Insert the SD card delivered with the system-on-module board (or follow the links above to create a boot image)
  • Power the board via PWR IN 12V MON DC
  • TI's PROCESSOR-SDK-J721E (e.g. 8.2)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

400px

Further Information

Further / detailed information regarding the Jacinto 7 evaluation platform as well as instructions how to setup an SD card image can be found here:

J721EXSOMG01EVM (TDA4VMx & DRA829Vx)

J7200XSOMG01EVM (DRA821)

Retrieved from "https://wiki.segger.com/index.php?title=TI_Jacinto_J721EXCP01EVM&oldid=16491"