Difference between revisions of "TI LP-EM-CC2340R5"
(Created page with "__TOC__ This article describes specifics for the TI LP-EM-CC2340R5 evaluation board.<br> '''[PICTURE OF BOARD]''' 450px == Preparing for J-Lin...") |
(→Example Project) |
||
(One intermediate revision by the same user not shown) | |||
Line 2: | Line 2: | ||
This article describes specifics for the TI LP-EM-CC2340R5 evaluation board.<br> |
This article describes specifics for the TI LP-EM-CC2340R5 evaluation board.<br> |
||
− | '''[PICTURE OF BOARD]''' |
||
[[File:TI_LP-EM-CC2340R5.jpg|450px]] |
[[File:TI_LP-EM-CC2340R5.jpg|450px]] |
||
Line 9: | Line 8: | ||
*Power the board via 3.3V DC (3.3V connected 3V3; GND connected to GND) |
*Power the board via 3.3V DC (3.3V connected 3V3; GND connected to GND) |
||
*Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
*Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
− | '''[PICTURE OF CONNECT]''' |
||
[[File:TI_CC2340R5_Connect.PNG|400px]] |
[[File:TI_CC2340R5_Connect.PNG|400px]] |
||
== Example Project== |
== Example Project== |
||
+ | The following example application contains a small blinky application and can be used to test & verify flash programming functionality on the TI LP-EM-CC2340R5 evaluation board. It is a simple blinky linked into the internal flash and contains a valid CCFG block. |
||
− | TBD |
||
+ | ====SETUP==== |
||
+ | *J-Link software: V7.88c |
||
+ | *Hardware: TI LP-EM-CC2340R5 |
||
+ | *Link: [[File:TI_LP_EM_CC2340R5_Blinky.zip]] |
Latest revision as of 09:53, 17 May 2023
This article describes specifics for the TI LP-EM-CC2340R5 evaluation board.
Preparing for J-Link
- Connect the J-Link to J4
- Power the board via 3.3V DC (3.3V connected 3V3; GND connected to GND)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example application contains a small blinky application and can be used to test & verify flash programming functionality on the TI LP-EM-CC2340R5 evaluation board. It is a simple blinky linked into the internal flash and contains a valid CCFG block.
SETUP
- J-Link software: V7.88c
- Hardware: TI LP-EM-CC2340R5
- Link: File:TI LP EM CC2340R5 Blinky.zip