TI LP-EM-CC2340R5
This article describes specifics for the TI LP-EM-CC2340R5 evaluation board.
Preparing for J-Link
- Connect the J-Link to J4
- Power the board via 3.3V DC (3.3V connected 3V3; GND connected to GND)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example application contains a small blinky application and can be used to test & verify flash programming functionality on the TI LP-EM-CC2340R5 evaluation board. It is a simple blinky linked into the internal flash and contains a valid CCFG block.
SETUP
- J-Link software: V7.88c
- Hardware: TI LP-EM-CC2340R5
- Link: File:TI LP EM CC2340R5 Blinky.zip