Difference between revisions of "TI LaunchPad CC1354P10"
Line 2: | Line 2: | ||
This article describes specifics for the TI LaunchPad CC1354P10 evaluation board.<br> |
This article describes specifics for the TI LaunchPad CC1354P10 evaluation board.<br> |
||
− | [[File:TI_LaunchPadCC1354P10.jpg|450px]] |
+ | </--TBD [[File:TI_LaunchPadCC1354P10.jpg|450px]]--> |
== Preparing for J-Link == |
== Preparing for J-Link == |
||
*Connect the J-Link to ...... |
*Connect the J-Link to ...... |
Revision as of 10:27, 3 February 2023
This article describes specifics for the TI LaunchPad CC1354P10 evaluation board.
</--TBD -->
Preparing for J-Link
- Connect the J-Link to ......
- Power the board via........
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the TI LaunchPad CC1354P10.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.86
- Embedded Studio: V6.34
- Hardware: TI LaunchPad CC1354P10
- Link: File:TI CC1354P10 TestProject ES V634.zip