TI LaunchPad CC1354P10
This article describes specifics for the TI LaunchPad CC1354P10 evaluation board.
Preparing for J-Link
- Make sure that the RST, TMS, TCK, TDD, TDI and SWO jumper are "disabled" (marked as number 1 in the screenshot above)
- Connect the J-Link to Target In (9-Pin Cortex-M connector; marked as number 2 in the screenshot above)
- Power the board via micro USB
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the TI LaunchPad CC1354P10.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.86
- Embedded Studio: V6.34
- Hardware: TI LaunchPad CC1354P10
- Link: File:TI CC1354P10 TestProject ES V634.zip