Difference between revisions of "TM4C123G LaunchPad"
(Created page with "The TI TM4C123G LaunchPad evaluation board does not come with an external debug connector. Therefore, in order to use an external debug probe, like the J-Link, at the first, t...") |
(No difference)
|
Revision as of 09:50, 23 May 2016
The TI TM4C123G LaunchPad evaluation board does not come with an external debug connector. Therefore, in order to use an external debug probe, like the J-Link, at the first, the Tiva C Series TM4C123G LaunchPad board needs to be manually setup:
- Solder a 7-pin strip header to DBG (see image below)
- Connect the debug interface signals manually (e.g. using jumping wires) as shown in the table below
TM4C123G LaunchPad | J-Link |
---|---|
TCK | Pin 9 (SWCLK / TCK) |
TMS | Pin 7 (SWDIO / TMS) |
TDO | Pin 13 (SWO / TDO) |
TDI | Pin 5 (TDI) |
RESET | Pin 15 (nRST) |
3.3V | Pin 1 (VTref) |
GND | Pin 4 (GND) |