ncoder N4 board

From SEGGER Wiki
Jump to navigation Jump to search
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.

This article describes specifics for the ncoder N4 evaluation board.

ncoder N4 board.jpg

Minimum requirements

  • J-Link software V7.70d or later

Preparing for J-Link

  • Connect the J-Link to the pins as seen in the image/table below:

ncoder N4 board connected.jpg

Cable JTAG-Pin
Red 3.3V
Blue TDIO
Black GND
Yellow TCK
Green RESET
Note:
For device reset to work as intended, RESET pin must be connected
  • Power the board via usb power supply
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

ncoder N4 board Connect.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ncoder N4 evaluation board. It is a simple Hello World sample linked into the internal flash.

SETUP