AICH ECBMCU105H

This article describes specifics for the AICH ECBMCU105H evaluation board. It can be used to test & verify 306xH device support.

Minimum requirements

• J-Link software V7.92o or later

Preparing for J-Link

• Connect the J-Link to the SWD header (J9) using single wires
  • Pin 1 - 3V3
  • Pin 7 - SWDIO
  • Pin 8 - SWDCK
  • Pin 4 - GND
• Power the board via external power supply USB (J6)
• Verify the Connection with e.g. J-Link Commander. The output should look as follows: