ArteryTek AT-START-F421
This article describes specifics for the ArteryTek AT-START-F421 evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
| J-Link Pin | Connector | Pin | Name |
|---|---|---|---|
| VTref | J1 | 24 | VDD |
| GND | J1 | 23 | GND |
| SWDIO | J1 | 10 | PA13 |
| SWCLK | J1 | 13 | PA14 |
| RESET | J2 | 7 | NRST |
- Power the board via CH4.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ArteryTek AT-START-F425.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.94h
- Embedded Studio: V7.20
- Hardware: ArteryTek AT-START-F421
- Link: File:Artery AT-START-F421 AT32F421C8T7 TestProject ES 7V20.zip
