CVA BlueWhale CVM0118-EVK
This article describes specifics for the CVA BlueWhale CVM0118-EVK evaluation board. It can be used to test & verify CVM011x device support.
Minimum requirements
- J-Link software V7.88 or later
Preparing for J-Link
- Select MCU to be powered (short JP8)
- Select MCU operating voltage 5V (short JP1 2&3)
- Select USB as power supply (short JP2 2&3)
- Connect the J-Link to the JTAG connector (J8)
- Power the board via external power supply USB (J11)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows: