Geehy APM32F091VCT6

From SEGGER Wiki
Jump to navigation Jump to search

This article describes specifics for the Geehy (Previously known as APEXMIC) APM32F091VCT6 evaluation board. It can be used to test & verify APM32F091xx device support.

Geehy APM32F091VCT6.jpg

Minimum requirements

  • J-Link software V7.70 or later

Preparing for J-Link

  • Connect the J-Link to the JTAG header (J5)
  • Power the board via external power supply USB (J2)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Geehy APM32F091VCT6 Connect.jpg

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Geehy APM32F091VCT6. It is a simple Hello World sample linked into the internal flash.

SETUP