GigaDevice GD32207I-EVAL

From SEGGER Wiki
Jump to navigation Jump to search

This article describes specifics for the GigaDevice GD32207I-EVAL evaluation board.
GigaDevice GD32207I-EVAL picture.jpg

Preparing for J-Link

  • Connect the J-Link to the JTAG header (JP1)
  • Power the board via CN2.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

GigaDevice GD32207I-EVAL GD32F207IK connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32207I-EVAL.
It is a simple Hello World sample linked into the internal flash.

SETUP