GigaDevice GD32L233R-EVAL

This article describes specifics for the GigaDevice GD32L233R-EVAL evaluation board.

Minimum requirements

• J-Link software V7.67c or later

Preparing for J-Link

• Connect the J-Link to the pins as seen in the image below:

• Power the board via usb power supply
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32L233R-EVAL. It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: V7.67c
• Embedded Studio: V6.22a
• Hardware: GigaDevice GD32L233R-EVAL
• Link: File:GigaDevice GD32L233R-EVAL TestProject ES V622a.zip