HDSC EV-HC32F460

This article describes specifics for the HDSC EV-HC32F460-LQFP100-050-V1.3 evaluation board.

Minimum requirements

• J-Link software V7.60b or later

Preparing for J-Link

• Connect the J-Link debug connector.
• Power the board via usb power supply
• The board should look like this:

• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the HDSC EV-HC32F460-LQFP100-050-V1.3. It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: V7.60b
• Embedded Studio: V5.60
• Hardware: HDSC EV-HC32F460-LQFP100-050-V1.3
• Link: File:HDSC HC32F460 TestProject ES V560.zip