HPMicro HPM5300EVK

From SEGGER Wiki
Jump to navigation Jump to search

This article describes specifics for the HPMicro HPM5300EVK evaluation board. It can be used to test & verify HPM53xx device support.

HPMicro HPM5300EVK.jpg

Minimum requirements

  • J-Link software V7.92e or later

Preparing for J-Link

  • Remove Jumper TCK, TDO, TMS, TDI, TRST
  • Connect the J-Link to the JTAG connector (J2)
  • Power the board via external power supply USB (J1)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

HPMicro HPM5300EVK Connect.PNG