HSXP HK32F030M

From SEGGER Wiki
Jump to navigation Jump to search

This article describes specifics for the HSXP_HK32F030M/0301M evaluation board. It can be used to test & verify HK32F03xx series device support.

HSXP HK32F030M.jpg

Minimum requirements

  • J-Link software V7.60c or later

Preparing for J-Link

  • Connect the J-Link to the SWD header (CN1) on the right side with jumper cables.
Board Pin J-Link Pin
GND GND (PIN4)
3.3V VTref (PIN1)
DIO SWDIO (PIN7)
CLK SWDCLK (PIN9)
RST RESET (PIN15)
  • Power the board via the USB connector

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the HSXP HK32F030M /HK32F0301M. It is a simple Hello World sample linked into the internal flash.

SETUP