Infineon XMC7200 Evaluation Kit

From SEGGER Wiki
Jump to: navigation, search

This article describes specifics for the Infineon XMC7200 Evaluation Kit.
Infineon XMC7200 Evaluation Kit.jpg

Preparing for J-Link

  • Connect the J-Link to 10-pin MCU PROG/DEBUG connector (J16)
  • Power the board via J6
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Infineon XMC7200 Evaluation Kit CONNECT.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Infineon_XMC7200 Evaluation Kit.
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=Infineon_XMC7200_Evaluation_Kit&oldid=14386"