Mindmotion-MB-036

From SEGGER Wiki
Jump to navigation Jump to search

This article describes specifics for the Mindmotion MB-036 evaluation board.

MM-MB-036-board.jpg

Minimum requirements

  • J-Link software V7.82e or later

Preparing for J-Link

  • Connect the J-Link: VTref= CN9-32(64 on PCB) / GND=CN9-31(63 on PCB) / SWDIO=CN9-14(46 on PCB) / SWDCLK=CN9-17(49on PCB)
  • Power the board via USB (CN2)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

MM MB-036 MM32F3270G7P Connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion MB-036 MM32F3277G7P.
It is a simple Hello World sample linked into the internal flash.

SETUP