NUCLEO-G431RB

This article describes specifics for the ST NUCLEO-G431RB evaluation board.
400px

Preparing for J-Link

• Power the board via Micro USB (CN1)
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

400px

• Note select device: "STM32G431RB".

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST NUCLEO-G431RB.
It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: V7.90
• Embedded Studio: V7.20
• Hardware: ST NUCLEO-G431RB
• Link: File:NUCLEO-G431RB Projekt.zip