NXP FRDM-MCXA156

From SEGGER Wiki
Jump to navigation Jump to search

This article describes specifics for the NXP FRDM-MCXA156 evaluation board.
NXP FRDM-MCXA156 MCXA156VL board.jpg

Preparing for J-Link

  • Connect the J-Link to J24, JP8 hast to set in order to disable MCU-Link on the PCB and work with J-Link.
  • Power the board via USB J21.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

NXP FRDM-MCXA156 MCXA156VL connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP FRDM-MCXA156.
It is a simple Hello World sample linked into the internal flash.

SETUP