NXP FRDM-MCXN236
This article describes specifics for the NXP FRDM-MCXN236 evaluation board.
Preparing for J-Link
- Connect the J-Link to J12, JP8 hast to set in order to disable MCU-Link on the PCB and work with J-Link.
- Power the board via USB J7.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP FRDM-MCXN236.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.94c
- Embedded Studio: V7.20
- Hardware: NXP FRDM-MCXN236
- Link: File:NXP X-FRDM-MCXN236 MCXN236 TestProject ES 7V20.zip