NXP FRDM-MCXN947

This article describes specifics for the NXP FRDM-MCXN947 evaluation board.

Preparing for J-Link

• Connect the J-Link to J23, J22 hast to set in order to disable MCU-Link on the PCB and work with J-Link.
• Power the board via USB J11.
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP FRDM-MCXN947.
It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: V7.94c
• Embedded Studio: V6.34
• Hardware: NXP FRDM-MCXN947
• Link: File:NXP MCXN947 TestProject ES V634.zip